Lithofin KF Protective Impregnator is a special product from the LITHOFIN-Range for fully vitrified porcelain and other ceramic tiles (KF). It is a water based nearly odourless impregnator consisting of a combination of high quality water and oil resistant components.

Lithofin KF Protective Impregnator penetrates into the micro pores of ceramic surfaces and effectively protects tiles and grout lines against staining by inhibiting the penetration of water, oil, grease and dirt. It does not affect the appearance of the surface while making it less sensitive and easier to maintain.

Lithofin KF Protective Impregnator is for all floors susceptible to staining such as in kitchens, work shops, etc. For protecting all absorbent ceramic tiles in order to facilitate maintenance.

Lithofin KF Protective Impregnator is ideally suited for treating polished porcelain tiles. It is suitable for indoor and outdoor use. Please Note: not all ceramic surfaces can be or should be treated. Not suitable for glazed surfaces.

Technical Data:
Density: approx. 1.0 g/cm³
pH-Value: approx. 5
Appearance: liquid, yellowish, clear
Odour: non specific
Flash Point: approx. 36°C (c.C.)

Directions for Use:
The surface to be treated must be completely clean and dry. For best results, treat the surface in sections of approx. 15m² at a time. Shake Lithofin KF Protective Impregnator well before use. Apply undiluted with a clean cloth or a lambs wool applicator and ensure even distribution by wiping over the surface several times. After 10 to 20 minutes, completely remove any surface residues with a squeegee and then with a dry cloth. Check surface for any residues, since these cannot be removed once fully cured. On large surfaces Lithofin KF Protective Impregnator can be applied with a sprayer and then immediately distributed evenly with a sponge. Product residues can be removed with a polishing machine and an absorbent pad. Attention! immediately wipe off puddles and drips. Do not allow the product to dry on the surface. Carefully remove all residues and check against back light. prior to use. Protect glass, varnished surfaces, plastics, etc. against splashes.

Application (Surface) Temperature: 10 to 25°C
Drying Time: Floors can be walked on after approx. 2 hours, fully dried out after 24 to 48 hours.
Coverage: up to 50m² per litre, depending on the absorbency of the surface.
Please Note: splashes on wood, glass, varnished surfaces, etc. should be wiped off with a moist cloth immediately. Application tools can be cleaned with water. Always test product in an inconspicuous area.

Durability and Further Care:
Treatment will last for 1 to 2 years depending on type, location and wear and tear. Lithofin KF Protective Impregnator can be touched up if required. Strong degreasing or leaching as well as layer forming cleaning products are not suitable.

Storage:
Keep closed, cool and dry. Shelf life of up to approx. 3 years. Open containers should be used without delay.